SVG Compensation YTPQC-SVG Static VAR Generator, IGBT switching compensation systems consist of high technology IGBT drivers and modules. SVG can perform both inductive reactive and capacitive reactive compensation in both directions. YTPQC-SVG compensation systems are designed for facilities with fast load change, where the reactive power limit is very important, and thanks to high speed and sens...
YTPQC-SVG Static Var GENERATOR Static Var Generator SVG works as a dynamic reactive power source, adopts high-speed computation components like DSP/IGBT, combining with super precise control program, following the grid current variation in real time, improving Power Factor value to 0.99 within 5ms. SVG represents the latest generation technology in the power factor correction field. By elimi...
The inductor is a component that can convert electrical energy into magnetic energy and store it. The structure of the inductor is similar to that of a transformer, but there is only one winding, which only hinders the change of current. If the inductor is in the state of no current passing through, when the circuit is connected It will try to hinder the flow of current through it. If the inductor...
Power Factor Correction Power Factor Correction improves the phase angle between the supply voltage and current while the real power consumption in watts remains the same, because as we have seen a pure reactance does not consume any real power. Adding an impedance in the form of capacitve reactance in parallel with the coil above will decrease Θ and thus increases the power f...
Effects of Harmonics : Increased losses Losses in capacitors The harmonic voltages applied to capacitors cause the flow of currents proportional to the frequency of the harmonics. These currents cause additional losses. Losses in conductors The active power transmitted to a load is a function of the fundamental component I1 of the current. When the current drawn by the load contains harmonics...
Why is the harmonic current on the null line mainly three times? This is due to two reasons: (1) Among the harmonic components generated by single-phase rectifier circuit, the third harmonic is the largest, and the distortion rate of the third harmonic usually reaches more than 80%. (2) The harmonic current of other times will have the effect of canceling on the zero line, onl...
What is power quality? The IEC (1000-2-2/4) standard defines power quality as follows: power quality refers to the physical characteristics of power supply devices that do not interrupt or interfere with users' use of power under normal working conditions. The most serious power quality problems are voltage sags and complete voltage interruptions. In fact, power quality refers to the...
Due to the rapid development of power electronic technology, the nonlinear characteristics of industrial and agricultural power loads, especially transportation and civil electrical products are becoming more and more serious, and the power factor of users is also declining. Therefore, reactive power compensation devices are more and more widely used. The power compensation device is used to suppl...
English
français
Deutsch
español
العربية
中文
IPv6 network supported
